Page 1 of 1

SM Setups

Posted: Tue Jun 27, 2017 5:04 pm
by tacolizard
The wiki one is getting boring, and every time I try to make my own custom setup the crystal delaminates. Pls halp.

Re: SM Setups

Posted: Tue Jun 27, 2017 5:05 pm
by Digdugxx
Let the crystal detonate to form a singulo, then set up a singulo engine as normal ^^

Re: SM Setups

Posted: Tue Jun 27, 2017 5:15 pm
by Anonmare
I have a gas mixer set-up to output a gas mix of 80% N2 and 20% CO2.
It's actually a lot safer than you might think and it outputs a lot of power.

33%O2 and 66% N2O is a decent hot mix, though it'll take time before it gets too hot but you can just open up the emergency freezers for a bit to cool it off.

I always replace the pumps with volume pumps since they don't choke as easily when the gas gets hot.

Re: SM Setups

Posted: Tue Jun 27, 2017 5:20 pm
by Kraso
freon is a naturally cold gas
you can fill heat exchange pipes with freon gas, eliminating the need for an active coolant gas in the chamber
do the math

Re: SM Setups

Posted: Tue Jun 27, 2017 8:56 pm
by TribeOfBeavers
I sometimes use ~10% N2O, ~8% plasma and ~82% CO2. You have to keep an eye on it, as it'll start to burn if the plasma goes up any higher. Set up a mixer or occasionally vent all the plasma to make sure it doesn't build up too much

Re: SM Setups

Posted: Wed Jun 28, 2017 3:55 pm
by MimicFaux
Wire the solars, you lazy bums!

Re: SM Setups

Posted: Wed Jun 28, 2017 10:49 pm
by oranges
Image

Re: SM Setups

Posted: Wed Jun 28, 2017 11:41 pm
by Kraso
Image
Image

NB: the heat exchange part between the freon and filtered back plasma can be ignored, just a little experiment I wanted to try out

Re: SM Setups

Posted: Sun Jul 02, 2017 11:48 am
by srifenbyxp
You should remove the SM and just use a PA like any normal person would.

Re: SM Setups

Posted: Sun Jul 02, 2017 4:01 pm
by danno
how the fuck do people still use things like shit image host

Re: SM Setups

Posted: Sun Jul 02, 2017 5:23 pm
by bman
the same way people still use internet explorer