Make it possible to rig a canister up to behave like a TTV bomb (As in, rig it up to be able to remotely open the valve with a signaller/prox sensors/voice analyzer/etc.)
To balance it out, make it time consuming and resource intensive to build a single canister bomb.
Resources to build:
Code: Select all
A gas tank (any kind)
Your choice of signaller assembly
A full length of cable coil
(Optional) 2 sheets of metal
A high capacity (at a minimum) power cell
Code: Select all
Use the screwdriver to unsecure the igniter.
Add the multitool to the igniter.
Add the assembly to the tank (as though you were making a single tank bomb).
Weld a hole in the tank
Secure the assembly with a screwdriver.
Use the cable coil on the assembly.
Place the assembly into the canister
Add your choice of detonator assembly (Signaller/VA/Prox etc.) to the canister
Place power cell in the canister
(Optional) Seal it up with two sheets of metal
It should look obviously like a bomb with bits of frazzled wire coming out of it and a piece of grey metal over where the tank normally goes. To disarm: Weld open the tank storage and use a screwdriver and wirecutters to unsecure the assembly and disable the detonator.
Optionally, I'd like to make a bomb requiring two "activator signals" (one to prime it and another to detonate it) and to make disarming a primed one require hacking but that might be asking too much. Plus I'd like to include a way of making it go off if the canister got too damaged, because just smashing it apart ought to be a viable (although dangerous) method of disarming it but a prepared bomb-maker should be able counter that.